dji Agras MG-1P 사용 설명서 - 페이지 5

{카테고리_이름} dji Agras MG-1P에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Agras MG-1P 17 페이지. Spreading systems
dji Agras MG-1P에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

e. Connect the cable to the Reserved Expansion Port 2 (7-pin) on the bottom of the aircraft body.

Usage

1. Open the cover of the spread tank as shown, add compatible materials, and close the cover.

2. Power on the remote controller, and then power on the aircraft.

3. Enter Operation View in the app.

4. To set the hopper outlet size, spinner disk rotating speed, and flying speed, tap the Spreading

Settings button

89%

that they are suitable for the materials you are using and test to make sure the performance is as

expected.

For the Spreading System 1.0, when measuring between 7.5 to 9 kg/ha of materials spread, it is

recommended to:

• Adjust the hopper outlet size so that the material delivery rate is 1 kg/min.

• Adjust the spinner disk rotating speed so that the spreading range is 4 to 6 meters.

• Set the flying speed to 4 m/s (flying speed setting is unavailable in Manual Operation Mode).

For the Spreading System 2.0, when measuring 45 kg/ha of materials spread, it is recommended to:

• Adjust the hopper outlet size so that the material delivery rate is 8 kg/min.

• Adjust the spinner disk rotating speed so that the spreading range is 5 to 7 meters.

• Set the flying speed to 5 m/s (flying speed setting is unavailable in Manual Operation Mode).

5. Enter the operation mode required for spreading. The operations of the Spreading System vary

depending on the operation mode.

, which is located towards the top of the interface. Adjust the settings so

M3×10 (Plus)

M3×12