dji AGRAS MG Series 사용 설명서 - 페이지 4

{카테고리_이름} dji AGRAS MG Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji AGRAS MG Series 17 페이지. Spreading systems

c. Remount the two landing skids using the eight M3×6 screws.

2. For the Spreading System 2.0, there is the option to mount the fender to the spreader. If

mounted, the fender will prevent materials from being spread to the rear of the aircraft.

5 cm

3. Mount the Spreading System to the aircraft.

a. Loosen the four M3 screws on fixing bracket on the left landing gear leg. Next, slide the fixing

bracket to a position 125 mm below the landing gear mounting base as shown below and

tighten the four screws.

b. Lift the spread tank with the mouth of the tank facing towards the rear of the aircraft.

c. Insert the plugs on the left landing gear leg into the mounting holes on the spread tank.

d. Slide the fixing bracket on the right landing gear leg to a position 135 mm below the landing

gear mounting base as shown below, and align the screw holes on the fixing bracket with the

fin on the right side of the spread tank. Tighten the two M3×12 screws, and insert and tighten

one M3×10 (Plus) screw.

M3×8