3idee hp-pav 조립 지침 매뉴얼 - 페이지 5

{카테고리_이름} 3idee hp-pav에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3idee hp-pav 6 페이지. Vesa adapter
3idee hp-pav에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (8 페이지)

Assembly

Assembly instruction

Step 1

Place your HP monitor securely on a soft surface.

Remove the base of your HP monitor if it is attached.

Loosen the screw that connects the base to your monitor and pull the base off.

Step 2

Now slide the 3idee VESA adapter into the mount of your

monitor as shown. (Figure 1)

A little force is required for this.

Step 3

Make sure that the hole in the monitor mount is aligned with

the hole in the VESA adapter.

Now use the included short screw and tighten the VESA

adapter to your monitor. (Figure 2)

Step 4

For this step we recommend a 2nd person.

Now lift the monitor and hold it to your monitor mount.

Fasten the VESA adapter with the 4 included M4x14 screws

(screw bag: SP2).

It is best to fasten 2 screws diagonally first, so that the

monitor cannot fall down and you can fasten the remaining

screws without any effort.

ATTENTION: Pay attention to the right screws!

(Figure 3)

instructions

Figure 1

Figure 2

Figure 3