ARTHUR HOLM AHDTL 사용자 설명서 - 페이지 8
{카테고리_이름} ARTHUR HOLM AHDTL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ARTHUR HOLM AHDTL 13 페이지. Universal motorized system for gooseneck microphones
ARTHUR HOLM AHDTL에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)
페이지 인쇄PRODUCT HANDLING
Please follow the figure below for a correct product usage of the
DynamicTalk microphones.
To avoid any product malfunctions, do not attempt to bend the
microphone to the incorrect angle or outside the microphone's working
area.
Please note that ware to the microphone and pop screen surface can
occur.
14
AHNET PROTOCOL
Communications protocol
COMMUNICATION
RS422
CONNECTION
RJ45
WIRING
CAT-5
Speed & configuration
BAUD RATE
38400
DATA BITS
8
PARITY
NONE
STOP BITS
1
Wiring Diagram
1. Data TX +
2. Data TX –
3. Data RX +
4. NC
5. NC
6 .Data RX
7. NC
8. NC
Connection
PINS 1 & 2
The units respond
PINS 3 & 6
The units receive instructions
Protocol
to
control
the
monitor
You can connect up to 30 monitors on the same RS422 bus.
It is possible to use a AH Interface Ethernet to control the RS422 bus.
The units should have a set address and the address must start by 1.
Maximum cable length between ends, 500m/1640 ft.
RJ-45
by
addressable
RS422
bus.
15