1 Sound LCC44 설치 매뉴얼 - 페이지 13

{카테고리_이름} 1 Sound LCC44에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 1 Sound LCC44 16 페이지.

Figure 27. Installing the LCC44 with the bracket

onto the mounting plate, overhead view.

• Lift the LCC44/84 enclosure with the bracket installed up to the

mounting plate on the wall. Carefully insert the tilt arms that

extend from the rear of the bracket in between the outer and

inner plates of the pan/tilt mechanism, and around the bolt that

locks the tilt.

Figure 28. Inserting the clevis pin.

• While maintaining a firm grip on the speaker enclosure, tilt it up

towards the mounting surface and align the holes in the bracket

with the holes in the lateral plates of the pan/tilt mechanism

(below the bolt that locks the tilt) and insert the clevis pin

completely through these holes until it protrudes from the other

side of the mount.

| 3 - INSTALLING LCC44/LCC84 ON A WALL MOUNT BRACKET

Figure 29. Replacing the R-Clip.

• Replace the R-clip (hairpin cotter) completely through the hole

in the clevis pin until it snaps into place.

Figure 30. Lowering the Speaker enclosure to its

maximum tilt.

• At this point, the speaker enclosure is secured to the mount.

Slowly lower the speaker enclosure until it stops at 40°. You

can now safely release the speaker enclosure and proceed with

securing the redundant safety cable and fixing the tilt and pan

angles.