Acova 3052-0005 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Acova 3052-0005에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acova 3052-0005 10 페이지.
페이지 인쇄
3)
USAGE
Press the ON / OFF button to turn on the
appliance.
The status light (bottom LED) is lit:
• green when the device is in standby mode,
• red when the device is heating up.
The device immediately starts to heat for 60
minutes.
To modify the current setting of timer, use the [+]
and [−] buttons. The timer can be set from 30 to
180 minutes in steps of 30 minutes. Each LED
represents 30 minutes.
The last LED blinks.
Press and hold the [+] button for 4 seconds to
activate constant heating. Towel dryer will heat
constantly unless it's turned off manually or by
power supply shortage.
In this mode all LEDs are lit without blinking.
This function could be disabled in advanced
settings.
Press the ON / OFF button to turn off the heating.
Appliance will go into stand-by mode.
EN | 12
As soon as the appliance is switched on, the electric heating
element heats the fluid, which gradually and naturally starts to
circulate inside the device. Depending on the model of device and
the room temperature, it takes approximately 30 minutes to reach
the optimal operating temperature. Due to the high inertia of the
fluid, the device remains warm for some time after being turned off.
TEMPERATURE REGULATION
The maximum operating temperature of towel
dryer is regulated by electronic controller.
To set the maximum temperature, first turn the
device off (go into standby mode using ON / OFF
button) and then press and hold the lower button
for 4 seconds.
Use [+] and [−] buttons to change setting of
operating temperature regulation:
• 45°C (blue LED),
• 55°C (green LED),
• 65°C (2 yellow LEDs) – default setting,
• 75°C (2 red LEDs).
Please notice, that presented values are
approximate and may slightly vary depending on
ambient circumstances.
Press the lower button once to store the setting
and go back to stand-by mode.
Press and hold the lower button for 4 seconds to
store the setting and go to advanced settings.
To cancel the setting and go back to stand-by
mode, press ON / OFF button or wait for 20
seconds.
EN | 13