dji PHANTOM 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} dji PHANTOM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji PHANTOM 17 페이지. Led indicator description & faq
dji PHANTOM에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지), 빠른 시작 매뉴얼 (8 페이지), 사전 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 마운팅 (2 페이지)

dji PHANTOM 빠른 시작 매뉴얼

Before Flying

1.
Installing the Transmitter Batteries
1. Open the battery compartment cover of the Transmitter.
2. Install 4x AA battery (5#) in accordance with the + /- pole.
3. Close the battery compartment cover of the Transmitter.
DO NOT use the PHANTOM transmitter (receiver) with the other third party remote control equipment.
 Risk of explosion if replaced by an incorrect type.
 Dispose of used batteries according to the instructions.
 Remove the batteries after use.
 When the voltage is lower than 4V, the transmitter will alarm with sound of "BB............", please change the
batteries.
2.
Battery Charging – LiPo Battery
Please use the full charged battery of 3S LiPo.
(Recommended parameters: 733496 - 2200MAH-20C-11.1V.)
The built-in ESCs of PHANTOM ONLY support 3S (11.1V) power supply. DO NOT use the battery of higher voltage.
3.
Fitting the Propeller
1. First prepare the aircraft and the propellers (original 8-inch).
2. Assemble the propellers (the side with rotary mark facing up) to the aircraft. Make sure the rotary mark on the
propeller is the same as the mark on the frame arm. The arrow's direction stands for the rotating direction of the
motors.
3. Finally fit the propeller nuts.
DO NOT use thread locker when mounting the propellers, just tighten the screws is enough.
©2012-2013
DJI Innovations. All Rights Reserved.
9 |