Acova 874100 사용 설명서 지침 - 페이지 16

{카테고리_이름} Acova 874100에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Acova 874100 20 페이지.

페이지 인쇄

C. To start the appliance, follow the same procedure as for an electric towel-

dryer.

If the central heating system is equipped with a circulation pump which is inde-

pendent of the boiler, it must in all circumstances be turned off (risk of siphoning

the heating unit in the event that connections are not perfectly watertight).IMPORTANT

The appliance should only be turned on when properly filled with water (failure to com-

ply may invalidate the guarantee).

IMPORTANT This radiator is equipped with a resistance which has an integrated

power shut-off and fuse. Using the radiator without water will permanently damage

the fuse as well as the resistance. In this case it must be changed though "not

under the manufacturer's guarantee". Using the radiator only partially filled with

water causes the heating function to shut off automatically. Alternate function will

continue as long as the main heating section is not properly filled.

If you notice that the electrical part of your towel dryer is activated, but that it

fails to heat up inspite of thermostat demand or positive working operation, carry out

the following operations:

1) Ascertain that your radiator is full of water (see paragraph B).

2) Press button

(see chapter 4.1) to stop current supply and stop the elec-

❶

trical function for 30 to 60 minutes. This operation is necessary to cut off the thermal

safety device.

3) Press button

again: the radiator is ready to heat up properly.

❶

4. Using your thermostat

4.1 Overview

❷ On indicator

❶ Heating stop/

start button

❸ Two-hour booster

button TIMER PROG

KEY TO INDICATOR LIGHTS:

Light indicating appliance is on:

❷

• Red: appliance on

• Off: heating stop

Functioning indicator:

❹

• Red: the set temperature is higher than that for the room; the appliance is

heating up.

• Flashing red: the booster function is on.

• Green: the radiator is heating up in reduced mode programmed by pilot wire

(ECO, COMFORT -1°C and -2°C).

• Off: the set temperature has been reached, the appliance has stopped

heating.

• Continuous green: the appliance is in freeze protection mode, programmed

by pilot wire.

4.2 Setting the temperature

Turn the appliance on by pressing the Heating stop/start button

indicator

will light up to show that the appliance is on.

❷

Thermostat setting: this function allows you to select the ambient temperature

of the room.

Turn the knob for temperature setting

tion. The red light

❹

40005972

❹ Functioning

❻ Knob for

indicator

temperature setting

❺ Adjustment

❼ Setting marker

dial

clockwise to activate the heating func-

❻

comes on when the setting exceeds the ambient temperature.

. The red

❶