ARTHUR MARTIN AFC4453MX 사용자 설명서 - 페이지 7
{카테고리_이름} ARTHUR MARTIN AFC4453MX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ARTHUR MARTIN AFC4453MX 15 페이지.
페이지 인쇄
SAFETY INSTRUCTIONS
The use of exposed flames is detrimental
to the filters and may cause a fire risk,
and must therefore be avoided in all
circumstances.
Any frying must be done with care in
order to make sure that the oil does not
overheat and ignite.
CAUTION: Accessible parts of the
hood may become hot when used with
cooking appliances.
For lamp replacement use only lamp type
indicated in the Maintenance/Replacing
lamps section of this manual.
WARNING! Do not connect the
appliance to the mains until the
installation is fully complete.
With regards to the technical and safety
measures to be adopted for fume
discharging it is important to closely follow
the regulations provided by the local
authorities.
The ducting system for this appliance
must not be connected to any existing
ventilation system which is being used for
any other purpose such as discharging
exhaust fumes from appliances burning
gas or other fuels.
Do not use or leave the hood without
the lamp correctly mounted due to the
possible risk of electric shocks.
Never use the hood without effectively
mounted grids.
The hood must NEVER be used as
a support surface unless specifically
indicated.
Use only the fixing screws supplied
with the product for installation or, if not
supplied, purchase the correct screws
type.
Use the correct length for the screws
which are identified in the Installation
Guide.
In case of doubt, consult an authorised
service assistance centre or similar
qualified person.
WARNING! Failure to install the
screws or fixing device in accordance
with these instructions may result in
electrical hazards.
Environment concerns
Recycle the materials with the symbol
. Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to
recycle waste of electrical and electronic
appliances. Do not dispose appliances
marked with the symbol with the
household waste. Return the product to
your local recycling facility or contact your
municipal office department for household
waste or the shop where you purchased
this product.
USE
The hood is designed to be used either for
or filter version
exhausting
INSTALLATION
The mains power supply must correspond
to the rating indicated on the plate
situated inside the hood. If provided with
a plug connect the hood to a socket in
compliance with current regulations and
positioned in an accessible area, after
installation. If it not fitted with a plug
(direct mains connection) or if the plug is
not located in an accessible area, after
installation, apply a double pole switch in
accordance with standards which assures
the complete disconnection of the mains
under conditions relating to over-current
category III in accordance with installation
instructions.
Warning! Before re-connecting the
hood circuit to the mains supply and
checking the efficient function, always
check that the mains cable is correctly
assembled.
7
.