dji Force Pro 사용자 설명서 - 페이지 11
{카테고리_이름} dji Force Pro에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Force Pro 11 페이지.
FCC Compliance Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received,including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate thereceiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RSS warning
This device complies with ISEDC licence-exempt RSS standard (s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including
interference that may cause undesired operation of the device.
Le présent areil est conforme aux CNR d'ISEDC licables aux areils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'areil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
SAR tests are conducted using standard operating positions accepted by the FCC/ISEDC with the device
transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the
highest certified power level, the actual SAR level of the device while operating can be well below the maximum
value. Before a new model is a available for sale to the public, it must be tested and certified to the FCC/ISDEC
that is does not exceed the exposure limit established by the FCC/ISDEC. Tests for each product are performed in
positions and locations as required by the FCC/ISEDC.
For body worn operation, this device
has been tested and meets the FCC/ISEDC RF exposure guidelines when
used with an accessory designated for this product or when used with an accessory that
Contains no metal.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.