FITNESS AUDIO SM-716 운영 매뉴얼 - 페이지 4

{카테고리_이름} FITNESS AUDIO SM-716에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FITNESS AUDIO SM-716 8 페이지. U series; v series
FITNESS AUDIO SM-716에 대해서도 마찬가지입니다: 운영 매뉴얼 (6 페이지), 운영 매뉴얼 (8 페이지), 운영 매뉴얼 (8 페이지), 운영 매뉴얼 (8 페이지), 운영 매뉴얼 (8 페이지)

페이지 인쇄

A double receiver rack mount kit is available as an optional extra if required (Fig. 4).

Positioning the Receiver

For best operation, the receiver should be at least 1m above the ground and at least 1m

away from a wall or metal surface to minimize RF re ections.

4. THE BELT-PACK TRANSMITTER (SM716)

Channel Selection and Gain

The channel selector and gain adjustment are located under the battery cover as

shown in the picture below. To make channel selection remove the cover and select a

channel by turning the Channel Selector(6) with a small screwdriver. Gain adjustment

for Lavalier and Headset microphones can be done by adjusting the MT trimpot(5),

whereas GT trimpot(4) is for the gain adjustment of an Electric Guitar or other high

impedance line level inputs. If you're using the Transmitter with an Aeromic then turn

down the MT trimpot to minimum. If

MT trimpot at full and turn down only if

distortion is evident.

Due to minor variations in the casing sizes

of many brands of 9V batteries, the trans-

mitter battery compartment is designed

to accommodate the preferred 9V size

battery made by Eveready - the Energizer

9V Alkaline – but other brands may also

work well. Re-chargeable Ni MH batteries

@ 170-190mAH ratings may need to be

re-charged after about 1.5 – 2.0 hours of

continuous use, whereas Alkaline 9V Bat-

teries will generally be suitable for about

6 – 8 hours of airtime with the Aeromic or

1. Battery Status Indicator

2. Power Switch

3. Microphone Connector

4. GT Trimpot

5. MT Trimpot

6. Channel Selector

Wireless Microphone System Operating Manual