fitness gear Ultimate Smith II 조립 설명서, 일러스트레이션 및 부품 목록 - 페이지 11
{카테고리_이름} fitness gear Ultimate Smith II에 대한 조립 설명서, 일러스트레이션 및 부품 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. fitness gear Ultimate Smith II 13 페이지.
페이지 인쇄
- 1. Important Precautions
- 2. Parts List
- 3. Bolts & Nuts Size Chart
- 4. Base Rail Assembly
- 5. Uprights and Lat Support Rails Assembly
- 6. Weight Bar Holder Guido Rods Assembly
- 7. Pec Deck Support Post Assembly
- 8. Weight Bar Assembly
- 9. Pec Deck Arms Assembly
- 10. Lat Cables Installation
- 11. Pec Deck Cables Installation
- 12. Low Row Pull Bar and Shoulder Pull Belt Assembly
- 13. Limited Warranty
v.7
STEP # 9 Low Row Pull Bar and Shoulder Pull Belt Assembly
l
Unwrap the pre-mslalled low row connector cable (47) from "18
DUHBYS (U1 8- UP.) located on the pee
deck suppert post (2) Connect the low row pull
bar (82) to the low row connector cable (47) using two
cable cltp's (84) and a low row chain (79)
2.
NOTE: Be sure that the low row connector
cable (47) is ln the groove of each Pulley and that
the Cable and Pulleys move smoothly.
3
Connect the shoulder pull belt (48) to the low row connector
cable (47) using a cable clip (34).
C/.\
50
I
:9"
IMPORTANT:
1.
Before each use, check the Cable Clips (84) on the e
v
nd
screw down pull pm (34) to ensure they are secure,y m
0' the cables and m:
2.
Before each use, pull the cables a few times to be sure that the cam" m
smoothly over the pulleys. If the cables do not mo
the problem.
"3 5mm", find and correct
3.
We suggest pen'odically using some silicone-based lubricant
beanngs'
located in the Weight Bar Holders (29 & 35) and on the squanon plasma} inner
sleeves (71) located in the weight plate holder: (10 & 17).
Speclflcauons sublect to change without node.
.. 19 ..