dji MATRICE 300 RTK 유지 관리 매뉴얼 - 페이지 10

{카테고리_이름} dji MATRICE 300 RTK에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji MATRICE 300 RTK 19 페이지. Dual gimbal connector
dji MATRICE 300 RTK에 대해서도 마찬가지입니다: 제품 정보 (17 페이지), 유지 관리 매뉴얼 (19 페이지), 사용자 설명서 (15 페이지), 빠른 시작 매뉴얼 (10 페이지), 제품 정보 (10 페이지)

페이지 인쇄

MATRICE 300 RTK Maintenance Manual

1. Air filters are not loose or damaged.

Motor Air

2. If they are loose or damaged, return to the

Filters

factory for repair.

1. Check the propellers for visible deformation,

severe wear, nicks, and cracks, and if there

are any foreign materials.

2. Clean the propellers with a dry soft cloth.

Propellers

3. Replace the propellers immediately if visible

deformation, severe wear, nicks, or cracks

occur. ※

4. Replace the propellers after flying over 300

hours or using for one year. ※

1. The propeller adapter screws are secure.

2. If the screws are loose, apply thread locker

and tighten the screws.

Propeller

3. The propeller adapters are not misshapen or

Adapters

broken.

4. Replace the propeller adapters if they are

misshapen or damaged.

※ It is recommended to replace the propellers only in an emergency situation during operations. After the emergency

flight is over, please contact DJI technical support or an authorized agent for overhaul as soon as possible.

Flight Controller

1. After the aircraft is powered on and self-check is complete, there are no error prompts in the app

related to the flight controller.

2. In outdoor open environments, GPS signal has four bars within 1 min after powering on the aircraft,

which indicates that the Home Point can be recorded automatically, and the RTK data meets the

heading measurement standard.

3. In outdoor open environments, the interference of the compass after calibration is less than 50.

4. Sensor bias is less than 0.05 after IMU calibration.

Aircraft Structure

Type

Inspection Process and Solutions

1. The aircraft body is clean and not damaged.

2. Clean the aircraft body with a clean and soft

Aircraft

cloth, especially for the lenses of the Infrared

Appearance

Sensing and Vision Systems and the heat

dissipation vents.

Illustrations