dji Cendence 사용자 설명서 - 페이지 7

{카테고리_이름} dji Cendence에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji Cendence 20 페이지.
dji Cendence에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지)

Preparing the Remote Controller

Put the battery into the Battery Slot, then slide it to the end until you hear a click.

Press the Battery Release Button before removing the battery.

Press the Battery Level Button once to check the battery level.

The remote controller is powered by a WB37 intelligent battery, which can be charged via the

charging port or by the WCH2 Intelligent Battery Charging Hub.

Using the Charging Port

The INSPIRE

2 charger is used as for example below.

Place the battery into the remote controller, and connect connector B of the battery power port, then

connect the battery charger to a power outlet (100-240V, 50/60Hz). When charging is complete, the

display on the remote controller will show 100%.

Charging Time: 2 hours and 24 min

Using the Charging Hub

The Inspire 2 Charger and the WCH2 Intelligent Battery Charging Hub are used for example below.

Place the battery into the Charging Hub, and connect connector B of the battery charger to the

charging hub, then connect the battery charger to a power outlet (100-240V, 50/60Hz). The

Charging Hub will intelligently charge batteries in sequence according to battery power levels from

high to low. The buzzer will begin beeping when charging is complete. Remove the battery or turn

off the Buzzer Switch to stop it.

Power Qutlet

100~240 V

(50Hz/60Hz)