Artico SY-PA500 사용자 설명서 - 페이지 10

{카테고리_이름} Artico SY-PA500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artico SY-PA500 16 페이지.

4. Sleep mode
Press the
The Sleep indicator light
other indicator lights will turn off.
When you use the air purifier in sleep mode, it will operate very quietly.
Press any of the buttons to switch off the sleep mode except the Filter and
Timer buttons.
Working status (Air quality light)
5.
The air purifier integrates a sensor which measure the quality of the air. The
air quality light automatically goes on when the appliance is switched on.
After a few seconds, the air quality sensors will automatically display the
color of the LED light that corresponds to the ambient air quality. Below is
the chart to understand Air quality level.
AQ Color
AQ Level
Standby status (Night light mode):
1.
When In standby mode, press the
mode.
2.
Press the
brightness.
3.
To turn off the light, press the
Setting the timer
6.
1. Press
different timer options (2, 4, 8 Hours).
2. The air purifier will automatically power off once the timer has elapsed.
Note: pressing the
timer
.
Filter replacement indicator
7.
When the filter indicator
The first option is to clean the filter. Take out the filter and clean it (do not wash).
Place the filter back in its compartment and check if the filter light is no longer on.
button to activate the sleep mode.
and the fan speed light
Blue
Very god
button once more to decrease the light effect to half the
to turn On or Off the timer function and to cycle through the
button or unplugging the air purifier will cancel the
lights up, this means the filter needs to be checked.
Green
Orange
Good
Unhealthy
button to turn on the amber light
button for the third time.
9
will turn on, while all
Red
Hazardous