AIMS Power CON120AC36/48VDC 사용자 설명서 - 페이지 8
{카테고리_이름} AIMS Power CON120AC36/48VDC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AIMS Power CON120AC36/48VDC 12 페이지. Ac converter / battery charger
페이지 인쇄
CAUTION
plugged into an AC outlet.
2.3
DC
O
utput
B
attery
2.3
DC
O
utput
B
attery
can
be
applied.
can
be
applied.
Step 1- Follow battery polarity guide located near battery terminal! Place the battery cable ring terminal
over AC Converter / Battery Charger's battery terminal. Tighten the M6*12 Screw. Do not place anything
between the flat part of battery terminal and the battery cable ring terminal, or overheating may occur.
DO NOT place anything between battery cable ring terminals and battery terminals. The
Caution!
terminal stud is not designed to carry current. Apply anti-oxidant paste to terminals after terminals have
been torqued.
Step 2- Connect battery cables to your batteries
1) Single battery connection: When using a single battery, its voltage must be equal to the voltage of
unit's nominal input voltage.
2) Series battery connection: When using multiple batteries in series, all batteries must equal in voltage
and amp hour capacity, and the sum of their voltages must be equal to the voltage of unit's nominal input
voltage.
Before connecting, power off the unit and make sure the AC cord is not
C
onnection
–
Battery
C
onnection
–
Battery
Figure 1: Single battery connection
should
be
connected
should
be
connected
- 8 -
first
then
AC
power
first
then
AC
power