djm direct 01985-V2 원본 사용 설명서 - 페이지 8

{카테고리_이름} djm direct 01985-V2에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. djm direct 01985-V2 17 페이지.

Attaching the Sub-Frame

1.Attach the legs(17) as shown in the picture. The ends of the

support struts are fastened using the same screws as the legs, as

shown in the picture.

2.Push the rubber feet (17a) onto the ends of the legs.

3.Screw on the cross braces (18 and 19). The long cross braces should

be installed parallel to the control/front side of the saw.

4.Screw on the leg support stays (17b) as shown in the picture. They

should be installed on the rear legs.

Riving knife and saw blade

Riving knife

Remove the saw table insert by undoing the screw (see picture) and

lifting out the insert.

Set the saw blade to its maximum height setting by turning the hand

wheel (13) clockwise.

Make sure that the tilt angle is set to 0° and locked using the lock

knob (14).

Place the riving knife over the alignment lugs.

5.Secure the riving knife with the washer and set screw making sure

that the arrow on the washer point s to the saw blade as shown in

the picture.