djm direct DJMBD13-40 원본 운영 매뉴얼 - 페이지 8

{카테고리_이름} djm direct DJMBD13-40에 대한 원본 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. djm direct DJMBD13-40 19 페이지. Bench drill

Drill Chuck

Fold the drill chuck guard upwards. Insert the drill

chuck on the taper of the drill spindle. Push the drill

chuck onto the drill spindle with a few light taps. Use a

plastic hammer for this purpose.

Drill Lifting Arms

Bolt the three drill lifting arms into the hand spindle

guide. Tighten the three hole lifting arms with an open

end wrench SW 6 (not scope of delivery).

Drill Chuck Key

Attach the drill chuck key into the key holder.

Depth Stop

1. Remove the washer and nut from the depth stop.

See below illustration 1.

2. Insert the depth stop through the hole in the fence.

See below illustration 2.

3. Screw the depth stop with washer and nut that

just had been removed from step 1. Centrally align

the depth stop into the bore of the fence. See below

illustration 3.

4. The home position of pointer should be 0mm. See

below illustration 4.