Cleerline SSF-TKITE-1MM 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Cleerline SSF-TKITE-1MM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cleerline SSF-TKITE-1MM 2 페이지. Fiber test kit
Cleerline SSF-TKITE-1MM에 대해서도 마찬가지입니다: 매뉴얼 (19 페이지)

페이지 인쇄

Cleerline SSF™ TKITE-100 Test Kit

theFOA.org

5. For single-ended testing, plug in appropriate

SC cable or LC cable with SC to LC adapters

(single mode or multimode according to the

cable being tested) between OLS and OPM.

Aqua = multimode. Yellow= single mode

theFOA.org

7A. Single-ended Testing:

Unplug connector from power meter side ONLY.

Place feedthrough SC or LC adapter, depending

on cable being tested, on connector.

Connect cable to be tested. The dB value that

appears center of screen (see step 7) is the loss

value.

Refer to the included FOA instructions "Guide to Fiber Optics & Premises Cabling" to perform A>B and B<A testing to properly

diagnose high loss connector terminations.

For accurate testing, frequent cleaning of all connector faces being placed under test, maintaining minimal bends and movement of

reference cables, and resetting of power meter reference throughout the course of testing are recommended.

theFOA.org

6. For double-ended testing, plug in two

appropriate SC cables or two LC cables with

adapters, one into OLS and one into OPM, with

SC connectors or LC to SC adapters into OPM

and OLS ports.

Link SC or LC ends together with feedthrough

adapter.

Meter

theFOA.org

7B. Double-ended Testing:

Unplug connector from SC or LC feedthrough

adapter. Place additional SC or LC feedthrough

adapter on connector.

Connect cable to be tested. The dB value that

appears center of screen (see step 7) is the

loss value.

SSF-TKITE-100/1MM/1SM Quick Start Guide

Meter

7.Reference OPM.

Once cable(s) are connected between OLS

and OPM units, press and hold "REF" button

for two seconds. OPM should now read 0dB.

Double-ended testing is optional

and requires additional reference

cables. Part Number:

SSF-REFCBL-MM = Multimode

SSF-REFCBL-SM = Single Mode

Performing Step 7 removes the

power loss of the "reference"

cables so that the dB loss reading

of the installed cables will not

include the loss of the reference

cable(s) utilized.

cleerlinefiber.com