Artillery Sidewinder-X1 설치 매뉴얼 - 페이지 2
{카테고리_이름} Artillery Sidewinder-X1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artillery Sidewinder-X1 2 페이지.
페이지 인쇄
Step 6
Connect the X carriage and filament runout sensor as
shown in picture to the base.
The flexible flat cable
(FFC) is wrapped around the X axis extrusion.
Step 9
Now you can connect power and turn on the machine.
On the touch screen, go to Tools -> Heat to pre-heat
the nozzle and bed. Wait till both heated up and
stead, go to Tools -> Level:
Step 7
Connect the FFC to the board on X gantry.
Step 9
Move the nozzle to all four corners, adjust the hiehgt
by turning the knob below the bed. Slide a A4 paper
between the nozzle and the bed, adjust the height so
that the piece of paper slides, with just a bit of drag,
in all locations of the bed.
You may need to do the same process twice becasue
adjustment in one corner will affect others.
Step 8
Adjust the tension of all the wheels on the machine. Try
to turn the wheels without forcing them. If the wheel
turns freely or without much effort, then it is too loose.
To tighten the wheels, rotate the eccentric nuts slightly
until the wheel is snug against the frame.
Tips
During printing, the LED near the nozzle shows the
current printing status:
- gradually change from blue to violet as the heated
bed gets to target temp.
- gradually change from violet to red as the hotend
gets to temperature.
- change to white to illuminate work surface.
- change to green once print has finished.
- turn off after the print has finished.
Also, you can change the LED color or turn it off
through the TFT touch screen.
Step 8
For wheels under build plate, please adjust the middle
wheel first, then move on to the others.
For support, please email to
or you can visit our Facebook group at
h�ps://www.facebook.com/evnovo
EVNOVO 3D Technology Co., Ltd.
Last update date: 19 February, 2019
This manual is updated to the date of printing.
Please refer to the electronic version if in doubt.