CLEMAP Load Management 설치 매뉴얼 - 페이지 3

{카테고리_이름} CLEMAP Load Management에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CLEMAP Load Management 13 페이지.

CLEMAP Load Management | Installation manual

Technical data

Power supply:

230V+/-10% 50/60Hz AC

Conforms to EU standards:

- RE Directive 2014/53/EU

- LVD 2014/35/EU

- EMC 2014/30/EU

- RoHS2 2011/65/EU

CLEMAP Load Management is used for dynamic power limitation of two or more electric charging

stations in a garage or car park. The power consumption of the entire building is measured and the

remaining available power for the charging stations is calculated and communicated in real time. The

load management status can be monitored and controlled historically and in real time via the online

portal CLEMAP Floem.

CLEMAP Load Management can operate in the local network and basically works perfectly even

without an internet connection. However, a temporary internet connection is required during the

installation phase. It is also recommended to install a permanent internet connection so that the

status of the charging stations can be monitored remotely via CLEMAP Floem after commissioning.

CLEMAP Load Management is installed in a fuse box and must be connected to the power supply lines

between the meter and the building. Usually there are three input lines in a building: the phase

conductors (L1=brown, L2=black and L3=grey) and as output the neutral conductor (also called

N=blue). The three current sensors must be connected to the three input lines.

Radio protocol:

WIFI 802.11b/g/n

WIFI frequency:

2.4 – 2.5 GHz

LAN:

RJ45 connector

Operating range

(depending on local construction):

- up to 50 m outdoors

- up to 30 m indoors

Dimensions (WxHxD):

105 x 86 x 59 mm

Power consumption:

<3W

Mechanical interface:

DIN rail