Artillian 1RMTBWM 설치 및 사용 설명서 - 페이지 2

{카테고리_이름} Artillian 1RMTBWM에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artillian 1RMTBWM 6 페이지. Artillian rops mounted tool bar wall mount

페이지 인쇄

This kit is designed to be mounted to flat

finished or most unfinished types of walls, with

adequate spacing to allow room for the Cam

Lever Latches to operate. The illustrations to

the right are for reference of various types of

installations.

WARNING

It is the user's responsibility to ensure that

installation of this product does not affect

integrity of the structure to which it is attached,

and that the structure is stable enough to hold

the Tool Bar and any of its accessories.

A minimum of 48 inches of unobstructed wall area

is recommended.

Brackets are intended to face outward as shown,

but may be turned inward if a viable wall stud is not

available far enough from a wall corner or other

obstruction.

For all types of wall construction:

1. Determine the desired installation height and

placement for the brackets. Mark for the holes

accordingly.

NOTE: Holes in the brackets are spaced 3.5 inches apart

vertically and centered around the tool bar.

Recommended spacing between mounting holes for the

brackets is 32 inches, but may vary from 24" to 36" depending

on the wall construction.

2. Refer to specific instructions on the next page for

recommended installation of the wall brackets for

the type of wall construction encountered.

NOTE: Wood screws (black) and concrete screws (blue)

have been provided in this kit and should be suitable for most

wood frame or concrete walls. These screws must penetrate a

minimum of 1 inch to hold securely. If the installation is into a

different material, it is the responsibility of the installer to procure

the appropriate fasteners for installation into such material.

3. Install both brackets to the wall. If using the screws

provided (or the equivalent size: 3/16" or #10), use

the included flat washers under the heads of the

screws.

Make sure to install the brackets as close to level

as possible. If using 3/16" or #10 screws, some

vertical adjustment is possible.

Attach the Tool Bar to the wall brackets using the

included U-shaped brackets, four 5/16-18 x 1" bolts

and nuts.

The tool bar is intended to be centered on the wall

brackets, but may be slightly off-center depending

on location of wall studs or other factors. Center the

tool bar to the wall mounts or to the space

available, as desired.

KIT INSTALLATION

Fig. 1 (Brackets on wall, facing outwards)

Fig. 2 (Brackets with one stud close to corner)

Fig. 3a (Bracket fasteners into wood frame wall)

Fig. 4 (Attach tool bar to wall brackets)

2 of 6

Screws

into stud