Artillian 1UTVRK 설치 및 사용 설명서 - 페이지 5

{카테고리_이름} Artillian 1UTVRK에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artillian 1UTVRK 8 페이지. Utv bed mounted tool rack

FEATURES

The Artillian UTV Bed Mounted Tool Rack allows for one or more Artillian ROPS Mounted Accessories to be

attached to the rack without reducing bed capacity.

The innovation of the design is that any of the compatible accessories can be installed or removed from the Tool

Rack in seconds, without the use of tools.

One job may require a toolbox filled with various hand tools. Another might necessitate a tool rack holding

assorted long-handle yard tools or maybe a chainsaw mount and fuel can holder.

With the effortless installation and removal of each accessory, you won't waste any time setting up your UTV to

carry the specific tool required for the job!

ATTACHING ACCESSORIES:

1. Figure 1 shows an example of a toolbox installed

on a ROPS Mounted Tool Bar. Installation onto a

UTV Mounted Tool Rack is the same.

2. To install an accessory, have both cam levers

rotated UP, then place onto the Tool Bar. See fig.

3. To secure the accessory to the mounting bar,

rotate both cam levers DOWN until they cam over.

See fig. 3.

NOTE: The accessory can be locked to the Tool Bar by

inserting a padlock through the holes in the mounting bracket

where shown.

4. To remove an accessory, rotate both cam levers

UP and lift the unit off of the Tool Bar.

OPERATION

Due to the excessive vibrations generated by a UTV, the

UTV Bed Mounted Tool Bar and Tool Rack fasteners

may loosen up over time. It is recommended that the

fasteners are checked and retightened, as required,

regularly.

FEATURES AND OPERATION

Fig. 1 (example of attaching a tool box)

rotate both cam levers up

to install an accessory

Fig. 2 (cam lever in the open position)

padlock holes

rotate both cam levers down

to secure the accessory

Fig. 3 (cam lever in the closed position)

5 of 8