Artillian 1RMBCH 설치 및 사용 설명서 - 페이지 4

{카테고리_이름} Artillian 1RMBCH에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artillian 1RMBCH 6 페이지.

ATTACHING AND OPERATION

ATTACH TO MOUNTING BAR:

Note: The Artillian ROPS Mounted Toolbar is designed to

hold multiple accessories at one time. If placed appropriately,

up to 3 separate accessories may be possible. For example,

the Chainsaw Mount, Fuel Can Holder, and Beverage Cooler

Holder were designed to fit on the toolbar simultaneously.

7. Figure 7 shows a beverage cooler holder installed

onto an Artillian ROPS Mounted Tool Bar.

8. To install the beverage cooler holder, rotate both

cam levers UP, then place onto the Tool Bar. See

fig. 8.

Note: if the Cam Lever Latches do not sit flush on the Tool Bar, one

of the clamp plates may not have been fully open. Simply remove the

beverage cooler holder, rotate the cam levers up and tilt the

beverage cooler holder away from you to ensure the clamp plates are

fully open, then reinstall on the Tool Bar.

9. To secure the beverage cooler holder to the Tool

Bar, rotate both cam levers DOWN until they cam

over. See fig. 9.

NOTE: For additional security, the beverage cooler holder can be

locked to the Tool Bar by inserting a padlock through the holes in the

mounting bracket where shown in fig. 9.

10. To remove the beverage cooler holder from the

Tool Bar, rotate both cam levers UP, then lift the

beverage cooler holder.

OPERATION

11. For optimal functionality, the cam lever latches are

factory assembled with some friction between the

cam lever and the housing. This ensures the cam

lever doesn't accidentally flip closed while the user

attempts to install it on the bar. If the cam levers

loosen up over time, simply tighten the nut and bolt

that secure the lever to the housing until the

desired resistance on the cam lever has been

achieved.

Fig. 7 (attaching a beverage cooler holder)

rotate both cam levers up to

install the beverage cooler holder

Fig. 8 (cam lever in the open position)

padlock holes

Fig. 9 (cam lever in the closed position)

4 of 6

rotate both cam levers down

to secure the beverage

cooler holder