Custom Crimp CC200 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Custom Crimp CC200에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Custom Crimp CC200 18 페이지. Dial micrometer style adjustment
Custom Crimp CC200에 대해서도 마찬가지입니다: 운영자 매뉴얼 (17 페이지)

페이지 인쇄

CRIMPING

Select the correct die for the combination of hose and fitting being

crimped. Consult the hose and fitting manufacturer's specifications

for the correct die to use and the final crimp diameter required.

The final crimp diameter will be the closed diameter stamped on the

face of the die plus the number shown on the micrometer gage. See

the micrometer setting example below:

Micrometer Setting Example

Each 100 on the micrometer dial represents 1 mm above the

closed diameter of the die set. For example, with a 57mm

die set installed and the micrometer set at 240 as shown in

the photo, the final crimp diameter would be 59.4 mm ( 57mm

+ 2.4mm)

Insert the hose and fitting in the crimper head to the correct depth

and press and hold the foot switch until the crimper shuts off. If the

AccuStop

coupling stop is being used make settings according to

instructions.

Check the finished crimp diameter with calipers to be certain that it is

within the hose manufacturer's specifications.

Innovating SMART Hose Assembly Solutions Since 1979