djpower WP-2 사용자 설명서 - 페이지 5

{카테고리_이름} djpower WP-2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. djpower WP-2 17 페이지. Bubble fogger

WP-2 Bubble Fog Machine

• Review in the scope of the acceptance test at least every four years by

an expert.

• Inspection by an expert at least once a year

How to proceed with overhead attachment:

Ideally, the device should be installed outside of the area where people are.

IMPORTANT! A high level of experience is required for overhead mounting. This

includes knowledge of working load calculations, knowledge of the

installation material used and knowledge of safety inspections of the material

used and the equipment, but the experience required is not limited to this

alone. Under no circumstances should you attempt the installation yourself

unless you are suitably qualified. Instead, hire a professional installer. Please

note that improper installation may result in personal injury and/or property

damage.

The device must not be installed within the reach of persons.

If the device is to be suspended from the ceiling or from high supports, work

must be carried out with truss systems. The device must never be installed in

such a way that it can swing freely in space.

Please note: Devices can cause serious injuries if they fall! If you have doubts

about the safety of a possible form of installation, then do NOT install the

device!

Before mounting the device, ensure that the mounting surface is capable of

supporting at least ten times the point load of the device's own weight.

Mount the device with the mounting bracket on a truss system using suitable

lifting gear.

When installing overhead, ensure that the device is always secured with a

safety rope that can carry twelve times the weight of the device. Only safety

arrester ropes with screw links are to be used. Hang the safety catch rope in

the catch rope hole in the mounting bracket or on the device. Route the

rope over the truss or other secure attachment point. Hook the end into the

screw link and tighten the locking nut securely.

The maximum fall distance of 20 cm must not be exceeded!

A safety arrester rope that has been subjected to the stress of a fall or that has

been damaged must no longer be used as a safety arrester rope. Adjust the

angle of inclination using the mounting bracket and tighten the locking

screws.

5 / 16