djpower X-4LED 사용자 설명서 - 페이지 4

{카테고리_이름} djpower X-4LED에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. djpower X-4LED 8 페이지. Co2 jet (single unit)

phenomenon.Because there is residual air in the pipes while connecting the first

time.

Safety attentions

While CO get through,everybody can't close to gas column right above.

Before interrupt,make sure there is no any gas in the pipes.

Operation Place should not too narrow,and must keep ventilated.

Other attentions

Clean the machine regularly in case of blocking phenomenon so that it can

length its lifetime.

The maximum life time of the connecting pipe is one year and it has to be

changed to a new one after one year.

Opening the package and inspecting the machine

When opening the machine,please make sure all the parts are included for

proper operation,and check if there is any damage caused by the

transportation.Shall you find any defects please do not plug in the

machine,make sure to contact your dealer.

The following parts should be included when the X-4 LED CO Jet machine

shipped from the factory:

X-4 LED Co Jet machine×1

Power Cord×1

User manual ×1

Instruction for instal

Ensure the machine and all the parts are in good condition. Put the machine on

flat and decide the position of each device.

Link all the devices with pipes ,adjust the nozzles'direction and fix them, connect

the devices to power supply by power cord. (Each device shall be connected to

the power supply by the separate power cord)