djpower X-1 사용자 설명서 - 페이지 5
{카테고리_이름} djpower X-1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. djpower X-1 8 페이지. Dry ice machine
페이지 인쇄
One power cord
2.
3.
One user manual
Operation
Place the machine on a firm and level surface where it will be used. Take off the
1.
lid and fill with about 5 gallons(18 liters) water(hot or cold). Connect the unit to
power, when the red light is on, it means the machine is heating up.
Plug the cord into a grounded 22-amp receptacle. The heater draws 11 amps at
2.
230 volts.
While the machine is heating up, raise the built-in basket to its highest level
3.
and fasten it with the black handle on the side of the machine.
4.
After steaming the water for approximately 30-50 minutes, the machine will be
ready to use.
Using protective gear load, the basket can hold 8 kilograms (about 18 lbs) of
5.
dry ice. Please Note: Usually the dry ice being used here cover 2/3 of the whole
basket. Put into the dry ice at the last possible moment when needed, because
the steamy atmosphere in the machine will make the dry ice inside evaporate if
it is put inside too long beforehand.
After holding the dry ice, tighten the lid, and screw the lid latch according to the
6.
instruction of imprint.
When the fog is in need, grasp the operation lever and slowly lower the handle.
7.
A full basket should not be plunged into the hot water completely, because the
violent dry-ice sublimating would result in high and dangerous pressure in the
housing . The operation lever is used to allow the basket to move up and down
in the water. As the solid CO is immersed, thick cloud-like fog will be produced
from the nozzle. To increase the rate, lower the lever to the end. Fully raising
the handle will quickly stop the fog output. Thus it is possible to realize the
"ON" and "OFF" control by adjusting the operation lever.
When the machine is to be emptied, allow it to cool. Empty the remaining water
8.
in the machine to buckets where the machine stands rather than carrying it to
drain. Do not move the machine with hot or boiling water in.
Maintainance
1.
Keeping lid latch slightly oiled will protect them and allow them to operate
easily.
2.
Make sure no other barriers in the rubber lid seal, otherwise it will allow gas
escape through the lid gasket.
When you heat up the machine, leave the lid off. This prevents the carry
3.
handles from getting hot before adding dry ice.
4.
Do not pour cold water directly onto hot heating element as this will cause
2
03