djpower TOPCAT CAT-2 사용자 설명서 - 페이지 11

{카테고리_이름} djpower TOPCAT CAT-2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. djpower TOPCAT CAT-2 13 페이지.

페이지 인쇄
djpower TOPCAT CAT-2 사용자 설명서
•
Under the DMX control mode, slide down channel 1 to OFF (value 0-10), then back to ON (value 11-255), to let the machine run again.
The warning will disappear until the fluid is pumped and fill the tube.
•
Turn off "Fluid Sensor" in the menu.
6

TECHNICAL INFORMATION

6.1

Maintenance

1、
Please use DJPOWER PRO Neutral Fluid only.
2、
Any reference to servicing in this User Manual will only apply to properly trained, certified technicians. Do not open the housing or
attempt any repairs which can lead to damage or malfunction.
3、
Excessive dust, fluid residue and dirt will degrade performance and cause overheating. Remove dust from air vents with air
compressor, vacuum or soft brush. The casing could be cleaned by the damp cloth.
Test-run your DJPOWER® CAT-2 on a monthly basis to achieve the best performance.
6.2
Storage
6.2.1
Machine Storage
Before storing the machine, clean it and empty the fluid tank.
6.3

Troubleshooting

Errors
Symptom
Refer to "MENU MAP" chapter to for more
No fluid
information
Refer to "MENU MAP" chapter to for more
Heating failure
information
Refer to "INSTALLATION" chapter to for more
Low pressure
information
Solution
Potential Cause
No fluid in the tank
Refill the fluid
Pump problem
Contact dealer for Service
Heater problem
Contact dealer for Service
Check the gas cylinder: if the hose is in
Low pressure
correct connection; if there is enough
gas in the cylinder