DJTECHTOOLS Midi Fighter 3D 사용자 설명서 - 페이지 7

{카테고리_이름} DJTECHTOOLS Midi Fighter 3D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DJTECHTOOLS Midi Fighter 3D 19 페이지.

Motion Messages

The Midi Fighter 3D carries an arsenal of electronic sensors which are used to track its

orientation and translate this into a variety of MIDI messages allowing highly expressive

control of your software. There are two types of orientation messages: edge tilt and button

rotation.

Edge Tilt Messages

The Midi Fighter 3D generates the following tilt based control change messages. All tilt

messages are sent on Channel 4.

Left Tilt | CC0

Forwards Tilt | CC1

Right Tilt | CC2

Back Tilt | CC3

In Traktor mode the Midi Fighter 3D also sends secondary tilt CC's. These operate over the

second half of the range of the primary CC.

Left Tilt Secondary | CC4

Forwards Tilt Secondary | CC5

Right Tilt Secondary | CC6

Back Tilt Secondary | CC7

While sitting ﬂat on the table all four CC's will be at zero, when the Midi Fighter 3D is tilted on

an edge it will send a CC which varies from 0 – 127 corresponding to its tilt angle on that

edge.

The Midi Fighter 3D also sends a channel 4 F0 note on event when any edge CC is active,

and note off event when all edges are inactive, i.e., the Midi Fighter 3D is ﬂat on the table.

As well as a note to indicate if the device is in edge tilt or not, the Midi Fighter 3D sends a

channel 4 F1 note on event whenever it detects that it has been picked up. This is Pickup

Mode.

Button Rotation Messages

The Midi Fighter 3D also generates rotation or "pitch" CC's for each arcade button.

There are 3 rotation modes, Relative (default), Absolute, and Disabled.

The rotation messages are only sent when a button is pressed, and the device is in "Pick Up

Mode"

Relative Mode

In relative mode when an arcade button is pressed, then the device is rotated a CC is sent

proportional to the change in rotation from the point at which the arcade button was pressed.

The CC is sent on channel 4 when the rotation is counter clock-wise, and channel 5

when the rotation is clock-wise.

! 7