Custom Dynamics CD-IND-WB 설치 지침 매뉴얼

{카테고리_이름} Custom Dynamics CD-IND-WB에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Custom Dynamics CD-IND-WB 2 페이지.

페이지 인쇄

Part Number: CD-IND-WB

Package Contents:

- MagicFLEX2® 6 LED Light Strip (1)

- 3M Tape Primer (1)

- Black wire 22 AWG (5 feet)

- 4" Tie Wraps (16)

- Heat Shrink Tubing (2)

Optional Items Sold Separately:

- Indian Engine LED Accent Light Kit (M2EK1-IND)

- Indian Wheel LED Kit (M2WK1-IND)

- Cage Clamp® (CG01) for wire connection (included w/lighting kits)

- Winter Kill Switch (SW01) to kill power to LED. (included w/lighting kits)

Fits: Indian® Motorcycles with the War Bonnet installed on front fender.

Important: Read all directions before starting project.

Caution: Always wear appropriate safety gear including safety glasses when

soldering or performing any electrical work. It is highly recommended that

safety glasses be worn throughout this installation process. Temperature of

bike must be at least 60 degrees F. for tape to properly cure. Be sure bike is

on level surface and secure and cool.

Important: Disconnect negative battery cable from battery; refer to owner's

manual. Failure do to so may result in electrical shock, injury, or fire. Secure

negative battery cable away from positive side of battery and all other positive

voltage sources on bike.

Note: If the War Bonnet LED is to be illuminated as a running light, the posi-

tive wire will need to be connected to a running light circuit.

If the War Bonnet LED is to be illuminated as an accent light, you must have

an on off switch and a fusible link between the LED and the power source.

See page 2 for wiring diagram.

Remove fender. Refer to your service manual for fender removal instruc-

tions.

Remove War Bonnet from the front fender by removing two 10mm nuts

on the under side of fender.

Remove 3 Phillips head screws from the bottom of the War Bonnet hous-

ing.

Note: 2 longer screws are for each side and the shorter screw is for the

back.

Questions? Call us at: 1 (800) 382-1388

Custom Dynamics® MagicFLEX2® Indian® LED War Bonnet Light Kit

We thank you for purchasing the Custom Dynamics® MagicFLEX2®

Indian® LED War Bonnet Accent Light Kit! Our products utilize the lat-

est technology and high quality components to ensure you the bright-

est, most reliable LED's on the market. We offer one of the best war-

ranty programs in the industry and we back our products with excel-

lent customer support, if you have questions before or during installa-

tion of this product please call Custom Dynamics® at 1(800) 382-1388.

M-TH 9AM-6PM / FR 10AM-6PM EST

Installation Instructions

Tools Needed:

- Screwdriver (Philips)

- Wire Cutter/stripper

- Heat Gun

- Open end wrenches

- Razor blade cutting tool

Cage Clamp® Instructions

Strip wire 9-10 mm. Use the stripped wire

gauge on the back of the connector to verify

correct strip length.

Push up lever and insert conductor

Push down lever to its closed position.

12-2017