DK Digital CDB-800 소유자 매뉴얼 - 페이지 6

{카테고리_이름} DK Digital CDB-800에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DK Digital CDB-800 17 페이지. Portable cd/mp3 radio recorder

Power supply

You can operate this device with the mains voltage of AC230V~ / 50 Hz, or with battery

power.

Mains operation

Connect the mains cord provided to a properly wired wall outlet with a voltage of AC230V~ /

50 Hz and to the mains socket on the rear panel of the unit. Now the device is operational.

Battery operation

Open the battery compartment on the bottom side of the unit. Insert 8 x 1.5V UM-1 "D" size

batteries (not supplied) into the compartment according to the insertion instructions in the

battery compartment. Observe the correct polarity of the batteries, as otherwise the device

may suffer damage. Due to their longer service life, we recommend you to use alkaline

batteries. Close the compartment again. Now the device is operational.

Batteries must not be thrown in the household waste. Please take used

batteries to the respective collecting points or take them there where

you have bought the new ones. Do not throw batteries into the fire.

Switch on the device by pressing the POWER button. Press the FUNCTION button

repeatedly in order to select the sound source that is to be played. The respective operating

mode is shown on the display:

"CDP" for CD playback,

"USB" for playback of USB storage media,

"SD" for the playback of memory cards,

"TUNER" for radio reception, or

"TAPE" for cassette operation..

Press the POWER button again in order to switch off the device. With the help of the

VOLUME buttons you can set the volume as requested. When you keep the VOLUME +

button pressed, the volume will increase. When you keep the VOLUME — button pressed,

the volume will decrease. The respective value (0 - 32) is shown on the display.

Headphone Operation

You can connect a headphone to the PHONE jack at the rear end in the device using a

3.5mm jack plug. This deactivates the build-in speakers.

Be careful with regard to your hearing. A too high volume may lastingly impair the

hearing ability of your ears.

Press the EQ button repeatedly in order to call up the sound pre-settings (CLASSIC, ROCK,

POP, JAZZ) one after the other. Select "FLAT" if you want to avoid any influence on the

sound.