Altronix eBridge8E 설치 매뉴얼 - 페이지 5
{카테고리_이름} Altronix eBridge8E에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altronix eBridge8E 12 페이지. Eight (8) port eoc receiver with integral poe+ switch
페이지 인쇄
Note: A constant PC connection is not required for proper operations and is used as a local programming/monitoring tool only.
Please note that all interconnecting equipment shall be UL Listed.
Step 1. Set Local Area Connection of your laptop to Static IP mode.
Static IP address of the laptop must be assigned to the same network as the current IP address of the eBridge8E unit.
The default IP address of eBridge8E unit is 192.168.168.168. This manual assumes that it has not been changed by user.
For Windows XP:
a. Open Network Connections by clicking Start button, then clicking Settings, then clicking Network Connections.
b. Right click the Local Area Connection. Click Properties. Administrator permission required If you are prompted for an administrator password
or confirmation, type the password or provide confirmation.
c. Double click Internet Protocol (TCP/IP) menu item.
d. Choose the Use the following IP address option.
e. Set the IP address to 192.168.168.15 (or another valid IP address on the same network).
f. Click OK. Close all windows.
For Windows 7:
a. Open Network Connections by clicking the Start button, clicking Control Panel, clicking Network and Internet, clicking Network and Sharing
Center, and then clicking Change Adapter Settings.
b. Right click the Local Area Connection icon, and then click Properties. Administrator permission required. If you are prompted for an administrator
password or confirmation, type the password or provide confirmation.
c. Click the Networking tab. Under this connection uses the following items, click either Internet Protocol Version 4 (TCP/IPv4) and then click Properties.
d. Choose the Use the following IP address option.
e. Set the IP address to 192.168.168.15 (or another valid IP address on the same network).
f. Click OK. Close all windows.
Step 2. Connect a laptop or PC to any of the Ethernet ports marked [1Gb] of your eBridge8E unit. The eBridge8E unit should be powered up at this moment.
Step 3. Open a browser window (it is necessary to update your browser software to the latest version so that the pages display and function correctly).
Step 4. Enter the eBridge8E IP address (the default IP address is 192.168.168.168) into the address bar. Status page will be displayed.
Step 5. Click Setup link. Setup page will be displayed. You may now program your EBridge8E unit.
All eBridge8E units come factory set:
a. Ports - Enabled.
b. Ports - PoE shutdown Disabled.
c. Power Allocation Mode - Class restricted.
www.altronix.com
User Interface and Programming:
- 5 -
eBridge8E