Artison Sketch LCR DualMono MK 2 설치 매뉴얼 - 페이지 2
{카테고리_이름} Artison Sketch LCR DualMono MK 2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artison Sketch LCR DualMono MK 2 4 페이지.
Artison Sketch LCR DualMono MK 2에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 빠른 참조 매뉴얼 (4 페이지), 빠른 참조 매뉴얼 (4 페이지)
페이지 인쇄
3-Channel Wiring
The diagram below shows connections to a multichannel amplifier with three separate front channels (left, right, and center). In this scenario, the
center channel is nominal 6 ohms in the parallel configuration shown.
2-Channel Wiring
The diagram below shows connections to a stereo amplifier with two separate channels (left and right). In this scenario, each channel is nominal
10 ohms.
Making Connections
The steps below describe how to connect a wire to the terminals on the rear of the speaker.
1. Strip insulation so there is ⅜ inch (9mm) of exposed wire.
2. Press down on the top of the round spring loaded terminal jack until the holes in the side of terminal align.
3. Insert wire into opening and release the terminal jack. The spring loaded terminal will now hold the wire securely in place.
4. Tug on the wire to ensure a secure connection.
HELPFUL!
–
#16 AWG is recommended for wire lengths up to 50 feet.
–
#14 AWG is recommended if wire length is longer than 50 feet but less than 100 feet.
–
#12 AWG is recommended if wire length is longer than 100 feet but less than 300 feet.
–
#12 AWG is the maximum wire gauge that will fit into the push pin terminals.
Masterpiece LCR Dual Center MK2 Installation Guide | 009-1625-02
Copyright 2020 Savant Systems, Inc | 200821
Rear View
of Speakers
Stage Tweeter
ON
OFF
Right
Speaker
+
—
Right
Rear View
of Speakers
Stage Tweeter
ON
OFF
Right
Speaker
+
Right
2
Stage Tweeter
ON
OFF
Left
Speaker
Amplifier
+
+
—
—
Channels
Left
Center
Stage Tweeter
ON
OFF
Left
Speaker
Amplifier
+
—
—
Channels
Left
www.savant.com/artisonspeakers
of
4
45 Perseverance Way, Hyannis, MA 02601
| 508.683.2500