Artison RCC300-CM 설치 매뉴얼 - 페이지 12

{카테고리_이름} Artison RCC300-CM에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artison RCC300-CM 15 페이지.

1. EQ – Select the appropriate setting based on these guidelines:

∞

Baffle – The RCC 300 Subwoofer Module is installed in a wall that has an air

volume of ≥1.4 ft

CLOSED BOX – The RCC 300 Subwoofer Module is installed in an Artison In-Wall

IMPORTANT: In an installation of two RCC300-SM's that are being powered by one

RCC300-SA, both Subwoofer Modules need to be in either Pre-Build Boxes or be in

Infinite Baffles. You cannot connect two RCC 300 Subwoofer Modules that are in

different environments to the same RCC 300 Subwoofer Amplifier.

PHASE – Comes from the factory set at 0°. The phase of the subwoofer can be adjusted

to fine tune the signal coincidence of the subwoofer and the lower frequencies of your LCR

Speakers. Adjust the phase, listening for an increase in mid bass in the crossover region.

A pink-noise generator or an RTA (Real-time Analyzer) can further analyze your

installation.

LOW PASS – This is the crossover frequency setting of the Low Pass Filter. The

RCC300-SA comes from the factory with the 80Hz setting that is recommended for use

with the Artison LCR speakers. If used in conjunction with any other speakers consult with

the manufacturer for the correct setting for the integration of the subwoofer with the

satellites.

4. SLOPE – Select either 12 dB/octave or 24 dB/octave for the slope of the Low Pass Filter

based on the correct frequency response at the crossover point. This can be done by

measurement or simply listening to the system. A proper crossover will not have an

apparent "hole" in the response nor will it exhibit the "bloated" mid bass sound that a peak

will create. Again, an RTA can come in handy during this part of the set up.

Pre-Build Box or is the RCC 300 Freestanding Subwoofer.