Artison RCC600-IWPBB 설치 매뉴얼 - 페이지 4

{카테고리_이름} Artison RCC600-IWPBB에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artison RCC600-IWPBB 10 페이지. In wall pre-build box

INSTALLING THE RCC 600 IN WALL PRE-BUILD BOX (RCC600-IWPBB)

1. The IWPBB was designed to fit into the bay of a stud wall that is constructed of

2x4

studs

spaced at 16" On Center. A deeper wall may be used but the stud spacing should still be 16"

On Center. Be sure that no piping or electrical wires interfere with the placement of the

IWPBB.

2. The front face of the IWPBB was designed to mount flush with the finished drywall surface.

The IWPBB has two mounting flanges with pre-drilled mounting holes that run along the two

longer edges of the enclosure. These secure the IWPBB to the two studs that make up the

stud bay.

3. When mounting the IWPBB, fasten 1 %" drywall screws through the pre-drilled holes in the

mounting flanges to the two studs on each side of the bay. This will ensure a safe and secure

installation.

4. The drywall thickness is critical to the mounting of the IWPBB.

a. If the construction calls for %" drywall, then the IWPBB should be mounted directly to the

studs. After the drywall is hung, the edges of the IWPBB should be taped, mudded and

sanded flush with the drywall. The IWPBB can then be painted or finished as the rest of

the drywall in the room. See Figure 1.

b. If the construction calls for %" drywall, then use the two spacers supplied to fur the

IWPBB out from the stud wall. After the drywall is hung, the edges of the IWPBB should

be taped, mudded and sanded flush with the drywall. The IWPBB can then be painted or

finished as the rest of the drywall in the room. See Figure 2.

c. The front edges of the IWPBB are chamfered to allow the mudding, taping and

sanding of all four edges flush with the drywall. See Figure 3.

5. The binding posts for the IWPBB are located at the top of the enclosure. They are connected

to an extension on the inside of the enclosure. Run and connect your speaker wire to these

binding posts before the drywall goes up and blocks access to them. Use the binding posts

instead of drilling a hole in the IWPBB, this will maintain the seal of the enclosure.