DK-TEC HNDK 사용자 설명서 - 페이지 10

{카테고리_이름} DK-TEC HNDK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK-TEC HNDK 15 페이지. Woodchipper for tractor

02/2020

Adjusting the rolling tension – how hard the roller holds the tree. There is 1 handle on each side.

Chipper's knives

IMPORTANT: The machine must be completely turned off and stopped before changing the

blades!

The flywheel and stationary blades must be sharp to get the chipper to do the work as expected.

When the blades have become lethargic, they can be turned 180 degrees as a result of which a

new knife appears. Open to the chipper's flywheel and loosen the 4 bolts that hold the blades and

then turn them over.

Be sure to tighten

the

mounting bolts of the blades when reinstalling the blades on

the

flywheel.

The stationary blades are designed with 4 sharp corners. When the corner opposite the

flywheel rounds, the knife is dismantled and another is installed. When installing new blades,

or when changing already existing blades, the blades are set in relation to the counter cutter

found by looking down into the flywheel. The blades should not hit the counter cutter, but

should drive as close to it as possible.

Adjustment of the counter cutter, is done by adjusting the bolts and their associated nut, as

shown in the photo below. These are found under thesv ing wheel, under the machine. Be sure

to re-tighten the bolts and nuts.

Roller speed control

On the left side of the insertion funnel, the roller speed

adjustment is found. 1 = slow - i.e. the chipper cuts the wood

into nicer pieces

10 =fast - ie. the wood chipper cuts

the

wood into coarser

pieces