DK-TEC HNEFG 사용자 설명서 - 페이지 12
{카테고리_이름} DK-TEC HNEFG에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK-TEC HNEFG 16 페이지. Flail mower
페이지 인쇄Installing the V-belt:
CAUTION: The strap is very tight; use caution to avoid bodily harm!
1. Remove strap guard and strap coverage.
2. Release the belt tension by loosening
3. With the tension relieved from the strap, the old strap is removed from the pulley
and a new one is inserted.
4. Tighten the belt tension bolt.
5. Replace the belt guard and belt cover .
Adjusting the height
To get the most out of your flail mower, it must be installed within the recommended height. To
spare fuel, power and reduce wear and tear on the machine, the cutting height must be adjusted
correctly.
When the working height needs to be adjusted, bolt No. 1 must be loosened, and bolt No. 2
removed on both sides. The height of the carrier roller (see drawing below) can be adjusted by
adjusting the selected hole in the carrier roller bracket in position 2. In the lowest hole, it is the
highest working height. Put the screw in the selected hole and tighten the screw from bolt No. 1
and bolt No. 2.
The rest of the height adjustment is made with a raise/lower
of the tractor's lift arms and corresponding adjustment of the
top bar.
Do not carry passengers on the flail mower:
Passengers can block the driver's sight and therefore
cannot see where they are being driven. Never allow
passengers on the flail mower.
Practical safety maintenance:
•
the maintenance procedures before starting maintenance. Use safe and
Understand
approved tools for maintenance. Read the manual for more information regarding
maintenance.
•
Maintenance should always be done in a dry room.
•
Lower the machine to the ground, put the tractor in
remove
key before performing the maintenance.
the
•
Before carrying out maintenance
•
Do not lubricate parts in grease or oil while the machine is working.
•
Inspect all parts. Make sure that all parts are in good condition and that they are correctly
installed before using the machine.
•
Remove accumulations of fat, oil and/or swans.
•
Remove all tools and unused parts from the machine before use.
tightening bolt until
the
the
all parts must be cooled.
,
strap can be removed.
the
parking, turn off the engine and
11