Artison RCC600-SA 설치 매뉴얼 - 페이지 12

{카테고리_이름} Artison RCC600-SA에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artison RCC600-SA 19 페이지. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Artison RCC600-SA에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지)

_ - - EQ MODES - - - .
fI'J
0
fI'J
w
~
~
>-
:)
m
«
to
C~R"~
JMITO EO
MIC
°O@
1. AUTO EQ MIC - This is the input jack for the ARMC Microphone.
2. Switch Settings - Select either:
a. BYPASS - ARMC not active.
b. AUTO EQ. - ARMC active. Will remember the last measured room mode sequence
and settings.
3. BLUE LED STATUS INDICATOR
a. Continuous Short Flash - Switch in AUTO EO setting, ARMC not yet saved. Since
the amplifier leaves the factory with this function having been tested the LED should
not flash continuously even when the switch is set to the AUTO EO position. NOTE: It
is important that you do a room mode set up using the supplied microphone at
your normal listening position if you plan to use the amplifier in this setting
b. One Long, Two Short Flashes - Amplifier Error, Shorted Audio Outputs. Remove
the speaker wires from the amplifier and use an ohm meter to check for shorts
in the line.
c. One Long, Three Short Flashes - Over Temperature Indicator. Be sure that the
amplifier has adequate ventilation. If the situation continues to exist contact
Artison.
4. Calibrate Button - Place the supplied microphone in the desired listening position and
plug it into the AUTO EO MIC input jack. Press the button for a few seconds to initiate
ARMC sequence.
12