DK-TEC SPLSE2206 사용자 설명서 - 페이지 13
{카테고리_이름} DK-TEC SPLSE2206에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK-TEC SPLSE2206 16 페이지. Mobile wood splitter, 22 tons 400 volt
페이지 인쇄6. Maintenance and storage
1. Never correct the safety devices. Check their proper function regularly.
2. Check bolts and screws for proper tightness at frequent intervals to keep the wood splitter in
safe condition. You should also visually inspect the wood splitter for any damage and repair if
necessary.
3. Before cleaning, repairing or inspecting, stop the engine (SPLSE2204) / Electrical
(SPLSE2206) and make sure the impeller and all moving parts are stopped. Disconnect the
spark plug cable.
4. Do not adjust the engine speed. The controller controls the maximum safe
operating speed of the motor.
5. Maintain or replace safety and instruction labels when necessary.
6. Follow these instructions for safe reading and unloading, transport and storage of the wood splitter
7. Never store the wood splitter or fuel tank indoors where there is an open fire, spark or
sleeper such as a water heater, oven, dryer, etc.
8. Always refer to the operating instructions for proper instructions for out-of-season storage.
9. If the fuel tank needs to be emptied, do this outdoors. (SPLSE2204)
10. Comply with laws and regulations available for gas, oil, etc. to protect the environment.
After performing the wood splitter maintenance, make sure that all screens and safety features
are properly put back in place. Failure to follow this warning could result in serious personal
injury.
See engine user manual for engine maintenance.
What
Snakes
Hydraulic fittings
Bolts and screws
Clover
Moving parts
Warning! Skin infection risk.
High pressure can act as a kind of injection of oil into the skin. It can cause injuries and in the
worst case, lead to amputation of a body part. So make sure all the fittings are tight, tight and in
order before using the clover. Never check for leaks or damage with the bare hands, use a piece
of paper or a safety glove. If you get oil injected into your body, seek medical attention
immediately.
Important! If a part needs to be replaced, use only parts that meet the manufacturer's
specifications. Replacement of parts that do not meet specifications may result in a safety
hazard or poor operation.
Storage
•
Before storing, make sure that the wood splitter is clean and dry to ensure years of
trouble-free service.
•
Lightly lubricate all surfaces and moving parts of the wood splitter to prevent rust.
•
Store the clover indoors or in a protected area from rough roads during the winter months.
When
Every time
Check for damage and leaks - must be repaired before
starting the engine.
Check for damage and leakage. Repaired before use.
Check for loose bolts
Regularly lubricate with grease
Remove obstacles and things that should not be there.
How