DK-TEC SPLSE2206 사용자 설명서 - 페이지 6
{카테고리_이름} DK-TEC SPLSE2206에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK-TEC SPLSE2206 16 페이지. Mobile wood splitter, 22 tons 400 volt
페이지 인쇄3. Instructions for safe use of the machine
Instructions
•
Read, understand and follow all instructions for the wood splitter found in the manual before
operating
the. Keep this guide in a safe place for later and regular reference.
•
Be familiar with all features and their proper function. You need to know how to stop the
tree clover and release it quickly.
•
Never allow children under the age of 16 to operate the wood splitter. Children aged 16 and
over must read and understand the instructions for use and safety regulations in this manual
and should be trained and supervised by an adult.
•
Never allow an adult to operate the wood splitter without proper instruction.
•
Keep bystanders, helpers, pets and children at least 7 meters from the tree clover , while in
use. Stop the tree clover if anyone enters the area.
•
Never drive the SPLSE2204 engine indoors or in a poorly ventilated area. The engine
exhaust contains carbon monoxide, an odorless but deadly gas.
•
Do not place your hands and feet near rotating parts or where the tree is located
on the clover. Contact with the rotating parts can amputate fingers, hands and feet.
•
Never attempt to clean the area where wood is operated or inspect and repair the wood
splitter while the engine is running. Switch off the engine and wait until all moving parts have
come to a complete stop. Disconnect the spark plug cable or at SPLSE2206 unplug the
power cord. (Do not use SPLSE2206 outdoors in rainy weather.
PREPARATION
•
Carefully examine the area where the wood splitter is to be used. Remove wooden parts or
other foreign objects that can be picked up or thrown out and cause personal injury or
damage to the wood splitter.
•
Always wear safety goggles or goggles when using the wood splitter or during adjustment or
repair to protect the eyes. Thrown objects can cause serious damage to the eyes.
•
Wear sturdy, non-slip work shoes and tight-fitting trousers and blouses. Never wear loose
clothing or jewelery when working with the wood splitter, as it can be caught by moving
parts. Never operate the tree clover in bare feet or sandals. Wear leather work gloves when
felling.
•
Before starting, check all bolts and screws for proper tightness to make sure the wood splitter
is in safe condition. You must also visually inspect the tree clover for damage at frequent
intervals.
•
Examine the wood splitter's safety device and function before each use.
•
Before starting, make sure that the hydraulic pipes and hoses are tight and test the stop
devices.
•
Always remove wood from the wedge before the next splitting.
•
Only an instructed person may operate the wood splitter.
•
The wood splitter may only be operated in an open space and on firm, level ground.
•
Use only an approved fuel can -
(SPLSE2204)
electrical installation.
•
Extinguish cigarettes, cigars, pipes and other sources of ignition.
•
Never remove the fuel cap or refuel while the engine is hot or running.
(SPLSE2204)
•
Allow the engine to cool for at least two minutes before refueling.
•
Never overfill the fuel tank. Do not fill the tank to more than 1/2 inch below the bottom of
the filler neck as the gasoline expands under heat.
Approved cable and
(SPLSE2206)
(SPLSE2204)
(SPLSE2204)
7