ALTUS APS-3 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} ALTUS APS-3에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALTUS APS-3 8 페이지. Positioning systems
ALTUS APS-3에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Battery Removal, Charge and Installation

Complete the following steps for removal, charge and

installation of APS-3 batteries.

One fully-charged battery can be used up to 5

hours.

Check which battery is "in use" before removal. See battery

status in collection software to replace battery "not in use".

See the Power or Battery Status Indicator section of this Quick

Start Guide.

Press battery release button to open battery

compartment door (FRONT)

To replace battery, pull or slide battery out

and close the compartment door

To charge battery, plug the AC battery

charger into the wall socket and power LED

turns ON

Place APS-3 battery in charger for 2 hours or

until LED turns GREEN for full charge. RED

LED indicates battery not fully charged.

Flashing RED indicates battery fault.

To load battery in APS-3, Slide the batteries

in the slot and close compartment door.