DK2 12SPS24 조립 및 작동 지침 - 페이지 11

{카테고리_이름} DK2 12SPS24에 대한 조립 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DK2 12SPS24 20 페이지. Electrical winch

p. The vehicle to be winched should be placed in neutral and the emergency brake

released. Only release the brake pedal when under full tension. Avoid shock loads to

the winch. This can damage the winch, rope and vehicle.

q. The winch is meant for intermittent use. Under full load with a single line rig do not

power in for more than a minute without letting the motor cool down for a few minutes

and then resume the winching operation.

r. The winching operation is complete once the vehicle is on stable ground and is able

to drive under its own power.

s. Secure the vehicle. Be sure to set the brakes and place the vehicle in park.

t. Release the tension on the wire rope. The winch is not meant to hold the vehicle for

long periods of time.

u. Disconnect the wire rope from the anchor.

v. Rewind the wire rope. Make sure that any wire already on the drum has spooled

tightly and neatly. If not, draw out the wire and re-spool from the point where the rope

is tight.

w. Keep your hands clear of the winch drum and fairlead as the wire rope is being

drawn in.

x. Secure the hook and hook strap.

y. Disconnect the remote control and store in a clean, dry place.

z. Clean and inspect connections and mounting hardware for next winching operation.

Periodically check the tightness of mounting bolts and electrical connections.

Remove all dirt or corrosion and always keep clean.

Do not attempt to disassemble the gear box. Repairs should be done by the

manufacturer or an authorized repair center.

The gear box has been lubricated using a high temperature lithium grease and is

sealed at the factory. No internal lubrication is required.

If the wire rope has become worn or is beginning to show signs of strands

breaking, it must be replaced before being used again. To do this, remove the

MAINTENANCE