DK2 Power OPC505AE 조립 설명서 - 페이지 11

{카테고리_이름} DK2 Power OPC505AE에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK2 Power OPC505AE 12 페이지. 5in autofeed chipper

OPERATION – BEFORE STARTING ENGINE

CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED.

THINK SAFETY. THIS CHIPPER CAN CAUSE INJURY IF SAFETY IS NOT

ENFORCED. ONLY ONE OPERATOR SHOULD WORK THIS UNIT. NEVER HAVE

ANOTHER PERSON IN THE AREA OR IN FRONT OF THE CHIP EXIT CHUTE.

IF YOUR UNIT WILL NOT START –

1. CHECK THE OIL LEVEL. YOUR ENGINE HAS A LOW OIL SHUTOFF PROTECTION

AND WILL NOT START IF LOW ON OIL.

2. MAKE SURE SPARK PLUG WIRE IS SEATED.

3. MOVE THE GAS LEVER ON TO THE RIGHT. LEFT POSITION IS OFF.

4. USE THE CHOKE IF NEED TO START IN COLD WEATHER.

5. CHECK YOUR GAS LEVEL

•

DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE RAM

•

ONLY CHIP WOOD, NO METAL OR PLASTIC OR RUBBER. WOOD ONLY.

•

CHILDREN SHOULD NOT RUN THIS EQUIPMENT

•

STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD APEAR IN THE

AREA WHILE YOU ARE WORKING.

•

LOAD TREES INTO FEED CHUTE. ADJUST FEED ROLLER TO SLOW FOR LARGER

TREES AND FASTER FOR SMALLER TREES. USE LEVER IN CENTER OF FEED CHUTE

TO CONTROL FORWARD/NUTRUAL/REVERSE OF FEED ROLLER.

•

IF ENGINE SPEED IS REDUCED WHEN CHIPPING ADJUST ROLLER SPEED.

•

WEAR SAFETY GLASSES, GLOVES AND PROTECTIVE SHOES.

•

OPERATE OUTDOORS ONLY – GAS FUMES ARE DEADLY INDOORS.

RUN ENGINE AT FULL RPM.

ALLOW MACHINE TO REGAIN RPM BETWEEN CHIPPING.

NEVER DISCONNECT SAFETY SWITCHES OR RUN WITH COVERS OPEN

REV 1 – 9-19-2019