Artiste ABH 102 매뉴얼 - 페이지 3

{카테고리_이름} Artiste ABH 102에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artiste ABH 102 4 페이지. Bluetooth

1. Ensure that the mobile device or a music player is on and the headset is closed.

2. Turn on the headset, Press the Pair button on the headset for 5 seconds until the Pairing LED (blue)

starts to flash quickly.

setting of your PC/Laptop, and select "ABH102"(ABH102 is the Bluetooth

3. Activate the Bluetooth

Headphone identity number of this sample).

4. When prompted and request for passkey, enter "0000" to make the connection of your PC/Laptop

to the ABH102 headphone.

5. Once both devices were linked, the Pairing LED (blue) of ABH102, headset will starts to flash slowly.

6. Plays the music with your computer and you can start enjoy the music with the headphone.

Press the control panel on the headset to control the audio streaming (Fast Forward, Fast Backward,

Pause/Play, Volume Up/Down)

Buttons

MIC

Play/Pause

LED(Blue)

Lock/Unlock buttons:

Press the PLAY/PAUSE button quickly twice to lock the other buttons and there will be a warning tone.

In locked state, only PLAY/PAUSE button is effective ,the other buttons are not effective. To unlock

buttons, Press the PLAY/PAUSE button quickly twice again.

Answer:

Press the play / pause button to pick up the call

Hung:

Press the play / pause button to hung off the call .when you don`t want to answer the call,press the

play / pause for 3 seconds.

Volume Up

Fast Forward

Fast Backward

Volume Down

Low battery alarm function: When the battery power is low, the headset will issue a "beep" sound

warning to turn off theheadset.

Automatically turn off function: If the headset is not connected with any equipment in about 10 minutes,

it will automatically shut down for power saving

Headset reset function:If the headset stop working,

you need to reset the headset, please connect the headset to a charging wire /adapter , then it will reset

successfully;If it is in working , when you connect it to a charging wire /adapter ,the headset will

automatically shut down, at this time please reset it for normal work. LINE IN function : When the

USB MIRCO is connected to the audio line (3.5MM TO USB MIRCO B/M), it will automatically disconnect

Bluetooth function and change to LINE IN, used as a wired headset.

Wearing

When wearing headset, please pay attention to distinguish between left and right side of the headband.

Headset on both sides has a telescopic headband design, you can adjust the headband length for more

comfortable .Stretch length was 30 ±1mm

Warning: Using the headset will weaken your ability to hear outside sounds. Therefore, please do

not use headset in the condition which may threaten your safety .

30±1mm