DK2 Power OPC566E FAQ 시트 - 페이지 3

{카테고리_이름} DK2 Power OPC566E에 대한 FAQ 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. DK2 Power OPC566E 13 페이지. Tips, tricks & frequent questions
DK2 Power OPC566E에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)

페이지 인쇄
DK2 Power OPC566E FAQ 시트
THE BASICS
HOW DO I START THE OPC566E?
STARTING
1.
Position your Wood Chipper on flat, dry ground.
2.
Make sure the fuel shut-off valve is in the
3.
Move the choke control lever to the
needed if the engine is cold).
4.
Move the throttle control lever to the
5.
Recoil Start: Turn the Ignition Switch to the
recoil starter handle and slowly pull until you feel resistance. Let the cord
retract a little bit then pull the cord rapidly to start the engine. One or two
pulls usually starts the engine.
6.
Electric Start: Turn and hold the key in the start position until Engine starts
then let the Key return to run position.
7.
Move the choke control lever (if used for cold engine) slowly back to the
"RUN"
position when the engine is running well.
8.
If the Wood Chipper has not been running (cold engine), warm up the
engine by running the engine at half throttle for 3 to 4 minutes, then advance
the engine throttle control to the maximum speed.
BACK TO MAIN MENU
"ON"
position.
"CHOKE"
position (should only be
"FAST"
position.
"ON"
position. Grasp the
3