DK2 Power OPD811 안전 및 작동 지침 - 페이지 8
{카테고리_이름} DK2 Power OPD811에 대한 안전 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DK2 Power OPD811 14 페이지. Big dump elec drive hydraulic dump
DK2 Power OPD811에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 조립 설명서 (11 페이지)
페이지 인쇄
PART III: Operating the BIG DUMP
It may be helpful to better familiarize yourself with the features of your machine
before beginning the steps outlined in this chapter.
WARNING
A. Read and understand all instructions, safety precautions, and/or warnings
listed in "PART I: General Safety Rules" before operating the machine. If
any doubt or question arises about the correct or safe method of performing
anything found in this manual, please contact DK2POWER.
B. Knowing the correct and incorrect methods of using the machine. Never
using an incorrect or unsafe method.
Before Using:
1. Using the battery charger supplied to charge the batteries until the green
light on the charger comes on.
2. Check the control cables, condition of wiring, tire pressure and all nuts/bolts.
Moving Forward：
1. Turn the MAIN SWITCH to "ON" position on the front panel.
2. Select "Forward" position on the toggle switch on the left handle.
3. Press the toggle switch forward.
4. Release the parking brake.
5. The speed of the dumper is controlled by the amount of throttle, which is on
the right handlebar. The throttle can be regulated to increase or decrease the
speed.
Moving Backward：
1. Release the right handle to stop the Dumper.
2. Move the switch toggle switch to "Backward".
3. Press the throttle to move the Dumper backward.
STOP:
Release the throttle. Use the hand brake on the left handle. The Dumper will
slow down and stop. Set the parking brake when not in use.
Part III: Operating the BIG DUMP
6