Artistic Licence dataLynx II 사용자 설명서 - 페이지 5
{카테고리_이름} Artistic Licence dataLynx II에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artistic Licence dataLynx II 13 페이지.
페이지 인쇄Power Supply & Earthing
The internal power supply requires an input
in the range 90-250 VAC with an Earth
connection. The mains fuse should only be
replaced with a 3.15A slow blow fuse.
The table below summarises the internal
Earth interconnection and isolation.
(Please note that we use the term Earth-
Ground to avoid international confusions. In
Europe Earth-Ground is called Earth; in the
USA Earth-Ground is called Ground).
Circuit
Chassis
Bonded to Earth-Ground
Type
Pin 1
DMX512
Ports
Shell
Type
Ethernet
Screen
Internal
Connects to Earth-Ground via 10
Logic
Ground
Ethernet Connection
dataLynx II has an RJ45 (Ethercon) connection
on the front panel. The product supports the
latest Art-Net release (Art-Net 4) and sACN
(the standard managed under ESTA E1.31).
dataLynx II requires Cat 5 cable or better and
supports 10BaseT and 100BaseT.
Ethernet Indicators
1.
2.
3.
4.
dataLynx II User Guide
Description
Ground referenced
Connects to Internal Logic
Ground
The connector shell is
connected to chassis
Transformer isolated
Connects to Earth-Ground
via 75 Ohm resistance &
100 pF capacitance, as
specified in IEEE standard
Ohm resistance
The front panel features 4 LED indicators: 1)
Power; 2) Net+Link; 3) 10/100/1000BaseT; 4)
Net Activity. These give different informational
signals depending on whether the product is
booting up or in operational mode:
During boot-up
Power
y
- Slow flashing green (1Hz) = booting
normally
- Slow alternating green/red (1Hz) =
factory start (settings cleared)
During operation
Power
y
- Static green = powered, normal
operation
- Fast flashing green (5Hz) =
- Occulting green = remote programming
command received
- Static red = fault condition
- Fast alternating green/red (5Hz) =
product is not commissioned (return
for service).
Net+Link
y
- Yellow = network link established (but
no lighting data)
- Green = Art-Net or sACN detected
10/100/1000BaseT
y
- Yellow = Ethernet link is 10BaseT
- Orange = Ethernet link is 100BaseT
- Green = SFP module
Net Activity
y
- Green = No network data
- Occulting Green = Network data
All indicators
y
- Off = mute command received
**The Power LED will flash continuously
when the Identify command is sent by
DMX-Workshop. This enables dataLynx
II to be easily distinguished on a network
containing multiple nodes.
This LED will also blip briefly in response
to any programming command received
via the network.
identify**
Page 5