Artistic License vSplit mono crmx-5 사용자 설명서 - 페이지 8
{카테고리_이름} Artistic License vSplit mono crmx-5에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artistic License vSplit mono crmx-5 14 페이지. Versasplit dmx/rdm; crmx; ethb input module
페이지 인쇄LED indicators
The CRMX wireless DMX module features
two sets of LED indicators.
On the left hand side, the strength of the
radio signal is indicated by green lights for
intensities of 20% and upwards. If the strength
drops below 10%, the bottom light turns red.
On the right hand side, there are 4 separate
LED indicators:
Status (refers to CRMX signal)
y
- Off: not linked to transmitter
- Green fast flash: linked but transmitter
not active
- Green slow flash: active radio link but
no DMX data
- Green: active with DMX present
Link - Green: transmitter active
y
DMX - Yellow: DMX present
y
Pow/Fix
y
- Green: power on
- Red (split mode): data error or collisions
detected
- Red (fix mode): data fixing is occurring
Ethernet input module B
Ethernet input module B enables versaSplit to
perform ethernet to DMX&RDM conversion.
The module requires Cat 5 cable or better.
Art-Net, sACN
y
10/100BaseT
y
LED indicators
y
RJ45 connector
y
versaSplit User Guide
LED indicators
The module features 3 LED indicators labelled
Status, Net and DMX. These give different
informational signals depending on whether
the product is booting up or in operational
mode.
The meanings are explained below.
During boot-up
Status
y
- Slow flashing green (1Hz) = booting
normally
- Slow alternating green/red (1Hz) =
factory start (settings cleared)
During operation
Status
y
- Static green = powered, normal
operation
- Fast flashing green (5Hz) = identify
- Occulting green = remote programming
command received
- Static red = fault condition
- Fast alternating green/red (5Hz) =
product is not commissioned
Net
y
- Yellow = network link established
- Green = Art-Net or sACN detected
DMX
y
- Green = Data activity
All indicators
y
- Off = mute command received
Page 8