Customatic FEATHER LITE 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Customatic FEATHER LITE에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Customatic FEATHER LITE 20 페이지. Adjustable bed

페이지 인쇄

Synchronizing two beds for tandem operation

To operate two adjustable beds simultaneously, you must pair both beds (Bed A and Bed B) to one remote control

(Remote A).

Plug both Bed A and Bed B to working and grounded electrical

outlets. A surge protector is recommended.

Before starting the sync process, press the

Remote A and Remote B to align the beds properly.

On Bed B, the LED light on the control box blinks three (3) times

once the power cord is plugged in, and is in learning mode for

seven (7) seconds.

During learning mode, use Remote A and press the

and

FOOT UP

buttons at the same time for three (3) seconds.

The LED light on the control box will light up and remain on,

which means the pairing is successful. Bed A and Bed B can

now be controlled simultaneously using Remote A.

NOTE:

When operating beds in tandem, both beds should be

plugged into working and grounded electrical outlets.

Resetting your system

Resetting the system is sometimes necessary to:

•

Restore the system to its factory setting.

•

Clear a system error.

•

Synchronize tandem units that no longer work in tandem.

•

Change a tandem system back to a single system or to two independent systems.

Unplug the power cord of your adjustable bed from the

electrical outlet.

Press and hold the

FLAT

sending a signal.

Plug the power cord back to the outlet and wait for seven (7)

seconds, then release the

NOTE:

The control box must receive the Flat signal from the

remote control for at least five (5) seconds after the power cord

is plugged back in. The reset is complete.

Remote Control Guide

FLAT

button on

button (without releasing) to continue

FLAT

button.

HEAD UP

LED light on the control box